Rugged & repeatable hand held gauges designed to non destructively measure the thickness of metal substrates whilst ignoring the thickness of up to 2mm ( 80mils) of an applied coating ( Echo to Echo mode) .

T92016967 5MHz High Damped Transducer - Steel Applications
T92016968 7.5MHz High Damped Transducer - Aluminium, Stainless Steel & Titanium Applications

Supplied with or without data logging, each gauge can be used with the wide range of measurement transducers and is supplied with a wide range of functionality including Scan mode and Alarm mode.

Elcometer 208DL only - ElcoMasterâ„¢ 2.0

Definitions:

Echo-to-Echo Mode:
Measuring materials as thin as 0.15mm ( 0.006� ) the Echo-to-Echo mode ignores the thickness of any coating applied to the surface under inspection.

Scan Mode:
Measuring up to 16 readings per second, the gauge captures the minimum recorded thickness.

Alarm Mode:
Once a minimum acceptable thickness has been set, a red LED illuminates and a buzzer sounds if a measurement falls below the preset value.

Elcometer has a wide range of transducers available for use with the Elcometer 205, 206, 206DL, 208 & 208DL Ultrasonic Thickness Gauges. When selecting a transducer, it is important to choose one which will meet the application, taking the following into consideration:

• The type of material to be tested.
• The design of the transducer probe.
• The measurement range.
• Whether the shape of that substrate is flat or curved or hard to reach.
Please note that transducers are consumables and wear out with use.

• A range of frequencies and sizes is available to meet specific needs.
• Straight and right angle transducers available as potted or microdot.
• Potted Transducers: the transducer cable is fixed to the transducer head on the cable to be replaced quickly and easily. These are more suitable for surfaces with a greater curvature and have a smaller footprint.
• High Temperature transducers: temperature up to 340° C ( 650° F) .
Select from transducer options

Definitions:

• Microdot Transducer:
The cable can be unplugged from the transducer and can be easily replaced on site should it become damaged.
• Potted Transducer:
Unlike the microdot transducers, the cables are hard wired into the transducer head.
• Exxon Specification
The gauge and transducer combination must hit specified standards without missing the first cycle.