Comprehensive Handheld Analyzer for 2M transmission, Datacom, Signaling, and Service Verification.

Feature :
Basic 2M and Datacom Testing

* Full duplex drop and insert testing
* Measurements include: G.821, G.826, M.2100, pulse mask, histograms, level & frequency measurements, and frequency stress testing
* Datacom testing at RS232/V.24, RS449/V.36, V.35, X.21/V.11, G.703 co-directional, and RS530 interfaces, including in-service monitoring between DTE and DCE equipment
* VF analysis: send/measure test tones, noise filters, digit capture & analysis, and CAS analysis
* 75 ohm unbalanced and 120 ohm balanced connectors

Frame Relay Networks

* UNI DTE and DCE emulation, NNI emulation
* Supports ANSI T1.617, ITU-T Q.933, LMI (GOF Vendors)
* Comprehensive LMI analysis
* IP PING test to verify end to end connectivity (RFC 2390) with In ARP support
* Load testing for verification of service
* In service statistic monitoring : UNI DTE, UNI DCE, NNI, UNI MON

Cellular Networks

* In-service time slot occupation analysis with voice decode and statistic analysis
* Out-of-service 16K BERT analysis
* Artificial voice generation
* A-bis protocol analysis
* BSSAP (MAP, DTAP) protocol analysis for interface A, B to G

Access Networks

* Primary Rate ISDN
* Testing for a variety of protocols (ETSI, AUSSI, DASS2, DPNSS, Q.SIG)
* Emulation of the terminal or the network
* Support 3 Time Slot (3 C-paths) monitoring simultaneously
* V5.1 and V5.2 Analysis
* Protocol analysis for in-service testing

Switching Networks

* Legacy signaling
* Emulation and Analysis of SS#5, MF(C)-R2, DTMF and PULSE
* User Emulator to allow the creation of personal emulation files
* CAS Analysis
* SS7
* Bi-directional SS7 protocol analysis
* Supports TUP, ISUP (ITU-T versions, Chinese versions), BSSAP (MAP + DTAP)

X.25